• +91 9990430009
  • admin@autoflege.com

DRYFIKS Hydroloq+

DRYFIKS Hydroloq+

ADVANTAGES

  • Withstands negative hydrostatic pressure of up to 4 bars (ASTM D7088).

  •  Offer superior efflorescence protection.

  •  Up to 70% substrate moisture is applicable.

  • A one-of-a-kind, brush-able, one-component product that is simple to use.

  •  A penetrating coating makes a porous substrate water-resistant.

  •  A pore-blocking layer prevents water from moving through the substrate.

  •  Outstanding anchoring and adhesion on a cementitious substrate.

Downloadable Resources

Get more information about this product with these downloadable files.
Product TDS

DRYFIKS™ Hydroloq+ is a one component, easy-to-apply, penetrative film forming interior waterproofing that provides effective solution to interior waterproofing problems like dampness and efflorescence. It forms a breathable, but water-tight film which doesn’t allow transport of water and salts to the surface.

Application Areas For Waterproofing In Construction

Roof slabs and screeds

Water tanks

Plasters

Bathrooms & Basements

Balconies

Septic tank, Sewage-disposal tank, Sewerage

Frequently Asked Questions

What are the available sizes for DRYFIKS Hydroloq+?

Packaging size of each product are 1 kg, 5 kg and 20 kg.

  • Fresh Plaster: Before applying, the masonry surface must be completely cured and free of efflorescence.
  • Using a brush without dilution, apply a single coat of DRYFIKSTM Hydroloq+ in a forced coverage of 3.5-4.5 sq.m/L.
  • DRYFIKSTM Hydroloq+ is not intended for use over substrate moisture levels of 70%, thus there should be no active leakage before application.
  • After using DRYFIKSTM Hydroloq+, refrain from using lambi putty or any other local putties.
  • Two wet-on-wet applications (with a 30-minute gap between coats) would be necessary for less absorbent surfaces in order to attain the forced coverage of 3.5-4.5 sq.m/L (40–50 sq.ft/L).
  • When brushing, please make sure that the coating fills all of the wall’s pores, corners, and joints.
  • Avoid covering the DRYFIKSTM Hydroloq+ with the topcoat.
  • If the outside temperature is below 10°C or could drop to this level within four hours of application, do not apply. Avoid using when the humidity is more than 90%.